ISSN: 2375-3846
American Journal of Science and Technology  
Manuscript Information
 
 
Developing the Footplate for Shower Drain Water Heat Recovery
American Journal of Science and Technology
Vol.1 , No. 3, Publication Date: Jul. 7, 2014, Page: 89-94
1566 Views Since July 7, 2014, 1383 Downloads Since Apr. 14, 2015
 
 
Authors
 
[1]    

Jing-Nang Lee, Department of Refrigeration, Air Conditioning and Energy Engineering, National Chin-Yi University of Technology, Taiwan.

[2]    

Duen-Sheng Lee, Graduate Institute of Mechanical and Electrical Engineering, National Taipei University of Technology, Taiwan.

[3]    

Cheng-Yan Yang, Graduate Institute of Manufacturing Technology, National Taipei University of Technology, Taiwan.

[4]    

Chien-Chih Chen, Graduate Institute of Mechanical and Electrical Engineering, National Taipei University of Technology, Taiwan.

[5]    

Chen-Ching Ting, Department of Mechanical Engineering, National Taipei University of Technology, Taiwan.

 
Abstract
 

This paper aims to develop the footplate for shower drain water heat recovery to capture the waste heat from the used hot shower water. In process, the used hot shower water is collected in a water tank and the cold water is guided into the pipe of the heat exchange device of piping tablet immersed in the water tank for heat exchanging. The heated cold water is further mixed with hot water as hot shower water, so that the required hot shower water rate is reduced and the energy consumption also reduced. The results show that employing one heat exchange device of piping tablet immersed into the ca. 40.6℃ water tank of 60 cm × 60 cm × 15 cm and the cold water with flow rate of 2 l/min got the heat exchange efficiency of ca. 44.34 %. Moreover, using three heat exchange device of piping tablet received the average heat exchange efficiency of ca. 94.21 % and the average heat transfer effectiveness(ε) was ca. 0.94.


Keywords
 

Shower Drain Water, Heat Recovery, Heat Exchange Device of Piping Tablet, Heat Exchange Efficiency, Heat Transfer Effectiveness (ε)


Reference
 
[01]    

C. C. Chen, W. Y. Yan, Y. Y. Wu, and C. C. Ting, “Investigating the Optimum Efficiency of Acoustoelectric Conversion Plate Devices, International Journal of Engineering and Technology Innovation,” in press, 2014

[02]    

J. N. Lee, C. C. Chen, and C. C. Ting, “Numerical Analysis of Exergy for Air-Conditioning Influenced by Ambient Temperature, International Journal of Engineering and Technology Innovation,” in press, 2014.

[03]    

C. C. Chen and C. C. Ting, “Photoelectrode Fabrication of Dye-Sensitized Nano Solar Cells using Multiple Spray Coating Technique, International Journal of Photoenergy,” 2013: Article ID 629059, 8 pages, doi:10.1155/2013/629059, 2013.

[04]    

C. C. Chen, D. Y. Tsai, C. C. Ting, and K. Y. Lin, “Improvement and Noise reduction for the Active Air Inlet Quick Burner by Using Dispersive Combustion Method,” American Journal of Energy and Power Engineering, 1: (1):1-8, March, 2014.

[05]    

H. Tsuchiya, “The Global Resource Balance Table, an Integrated Table of Energy, Materials and the Environment,” Energy Policy, vol. 61, 2013, pp. 1107-1110.

[06]    

H. Yang, P. Cui, Z. Fang, “Vertical-Borehole Ground-Coupled Heat Pumps: A Review of Models and Systems,” Applied Energy, vol. 87, 2010, pp. 16-27.

[07]    

J. M. Choi, Y. J. Park, S. H. Kang, “Temperature Distribution and Performance of Ground- Coupled Multi- Heat Pump Systems for a Greenhouse,” Renewable Energy, vol. 60, 2013, accepted. pp. 1-7.

[08]    

A. Arteconi, C. brandoni, G. Rossi, F. Polonara, “Experimental Evaluation and Dynamic Simulation of a Ground Coupled Heat Pump for a Commercial Building,” Energy Research, vol. 37, 2013.

[09]    

C. C. Ting, C. C. Chen, “Developing the Coaxial Dual- Pipe Heat Pipe for Applications on Heat Pipe Cooler," Journal of Heat transfer of the ASME, vol. 133, 2011, pp. 092901-1-7.

[10]    

C. C. Ting, C. C. Chen, “Experimental Analysis of Heat Transfer Behavior inside Heat Pipe Integrated with Cooling Plates,” Engineering, vol. 3, 2011, pp. 959-964.

[11]    

H. N. Chaudhry, B. R. Hughes, S. A. Ghani, “A Review of Heat Pipe Systems for Heat Recovery and Renewable Energy Applications,” Renewable and Sustainable Energy Reviews, vol. 16, 2012, pp. 2249-2259.

[12]    

W. Kempton, “Residential Hot Water: A Behaviorally- Driven System,” Energy, vol. 13, 1988, pp. 107-114.

[13]    

A. McNabola, K. Shields, “Efficient Drain Water Heat Recovery in Horizontal Domestic Shower Drains,” Energy and Buildings, vol. 59, 2013, pp. 44-49.

[14]    

L. Liu, L. Fu, Y. Jiang, ”Application of an Exhaust Heat Recovery System for Domestic Hot Water,” Energy, vol. 35, 2010, pp. 1476-1481.

[15]    

Y. A. Cengel, “Heat Transfer: A Practical Approach [3nd Edition],” ISBN-13:978-007-125739-8, 2007, pp. 620-622.





 
  Join Us
 
  Join as Reviewer
 
  Join Editorial Board
 
share:
 
 
Submission
 
 
Membership