ISSN: 2375-3846
American Journal of Science and Technology  
Manuscript Information
 
 
Drag Reduction by Fluid Slip
American Journal of Science and Technology
Vol.2 , No. 3, Publication Date: Apr. 28, 2015, Page: 106-110
1998 Views Since April 28, 2015, 1435 Downloads Since Apr. 28, 2015
 
 
Authors
 
[1]    

K. Watanabe, Science and Engineering Research Institute of Kokushikan University, 4-28-1 Setagaya, Setagaya-ku, Tokyo, JAPAN.

 
Abstract
 

Drag reduction technique is receiving a lot of attention from view point of energy saving in fluid engineering. It can be considered that the target is a turbulence modification for turbulent flow in order to reduce the pressure loss or drag. However, it is no effect for laminar flow range because the turbulence does not exist in the flow. If fluid slip occurs at the wall surface, we can obtain the drag reduction even if it is the laminar flow range. In this paper, some experimental results of laminar drag reduction are described and discussed for its application.


Keywords
 

Fluid Mechanics, Newtonian Fluids, Fluid Slip, Laminar Drag Reduction, Circular Pipe Flow, Friction Factor, Flow past a Sphere, Drag Coefficient


Reference
 
[01]    

Watanabe, K., (2015), Laminar Drag Reduction, Bentham Sci. Pub. Ltd, 1-105.

[02]    

Schnell, E., (1956), Appl. Phys., 27, 1149-1152.

[03]    

Churaev, N. V., Sobolev, V. D. and Somov, A. N., (1984) ,J.Colloid. Interface Sci. 97, 574-581.

[04]    

Tretheway, D. C., and Meinhert, C. D., (2002) , Phys. Fluids 14, L9.

[05]    

Luck, S., Mutharasan, R., and Apelian, D. (1987), Ind. Eng. Chem. Res., 26 (8), 1609-1616.

[06]    

Watanabe, K., Yanuar and Udagawa, Y., (1999) J. Fluid Mech., 381, 225-238.

[07]    

Navier, C.L.M.H., (1823), Memoires de l’Academie Royale des Sciences de l’Institut de France, 6, 389-440.

[08]    

Watanabe, K., and Udagawa, H., (2001), AICh E.J., 26, pp.729^739.

[09]    

Luaga, E., and Stone, H.A.(2003), J.Fluid Mech., 489, 55-77

[10]    

Watanabe, K., et al.,(2005),Trans. of JSME (Se. B),71-712, 2843-2847.

[11]    

Watanabe, K., and Ogata, S., (2002), Patent in Japan, 2002-115591.

[12]    

Fujita、T., and Watanabe, K., (2004), Proc. of 2004 ASME Heat Transfer/Fluids Engineering Summer Conference, HT-FED2004-56046, 1-6.

[13]    

Lapple, C. E. , and Shepherd, C. B., (1940), Indust. Eng. Chem., 32, Vol 5, 605-617.

[14]    

Fujita, T., and Watanabe, K., (2004), ASME IMEC&E '04, IMECE2004-62223, 1-6.





 
  Join Us
 
  Join as Reviewer
 
  Join Editorial Board
 
share:
 
 
Submission
 
 
Membership